|
Description: The new F 45 ELMO has been fundamentally redesigned. The result is a high-tech
modular system, which handles even the most challenging technical requirements of the saw user. The low-reflection 12 inch colour LCD display with touch screen functionality is new. This display method makes for straightforward operation through a self-explanatory, graphics-oriented approach to control. The display shows 90% of the applications, thus cutting down on time spent navigating. The USB port for data exchange and backup is also new. A further innovation is the crosscut-mitre fence on the F 45 ELMO IV, which can be adjusted to any angle between 0 and 47 degrees and has integral length compensation.
There are two versions of the F45 ELMO with either three or four motorised axes (F 45 ELMO III and F 45 ELMO IV respectively). Each of these machines can be equipped with optional extras to meet your own individual requirements.
In 2007 the jury of the International Forum Design presented its iF gold award for outstanding product design to the F 45 ELMO.
Sliding Table Cutting Lengths:
Maximum cutting lengths when using clamping shoe or crosscut-mitre fence. Not in conjunction with crosscut fence, stops to 2500 mm.
Table length (mm):
2250, 3000, 3200, 3400, 3800, 4300, 5000
Cutting length (mm) with or without scoring saw blade:
2155, 2905, 3105, 3305, 3705, 3870(4205*), 3870(4905*)
Cutting length (mm) for F 45 ELMO IV with or without scoring saw blade:
2100, 2850, 3050, 3250, 3650
TIP-SERVO-DRIVE
Cutting length (mm) without scoring saw blade:
1840, 2590, 2790, 2990, 3390, 3870, 3870(4570*)
Cutting length (mm) with scoring saw blade:
1725, 2475, 2675, 2875, 3275, 3775, 3775(4475*)
* Possible cutting lengths without use of the crosscut fence and cross slide.
Cutting lengths refer to mechanical travel, i. e. from end stop to end stop on the sliding table.
Depth Of Cut:
Without scoring saw blade
Saw Blade Diameter (mm):
250, 300, 315, 350, 400, 450, 500, 550
Depth of cut vertical (mm):
0-50, 0-75, 0-82, 0-100, 25-125, 50-150, 75-175, 100-200
Depth of cut at 45 degrees (mm):
0-33, 0-50, 0-56, 0-70, 17-87, 34-105, 52-123, 70-141
With scoring saw blade
Saw Blade Diameter (mm):
250, 300, 315, 350, 400, 450^, 500^
Depth of cut vertical (mm):
0-50, 0-75, 0-82, 0-100, 0-125, 25-150, 50-175
Depth of cut at 45 degrees (mm):
0-33, 0-50, 0-56, 0-70, 0-87, 16-105, 34-123
^ If a scoring unit is fitted, the scoring saw blade, incl. front and back flanges, or RAPIDO must be removed.
£POA
|
 |
